• Uncategorized
  • 0

Points to pay attention to when working with jaw crusher

When new and old customers use coal testing Granite Stone Crusher Machine for testing, they need to use auxiliary tools such as jaw crusher and hammer crusher, such as in calorimeter, sulfur analyzer and muffle furnace experiment. Used to make standard coal samples. We all have these auxiliary equipments, so the technicians are very familiar with these equipments. Today, we will explain to the new and old customers the following precautions when working with the jaw crusher and hammer crusher:

The Jaw Crusher Price shall check the operation, and there shall be no abnormal knocking sound inside the jaw crusher. Special circumstances should be stopped immediately. The grain size of the I mine is not more than 0.8 times that of the ore supply. The lower part of the discharge chute and the broken cone should not be blocked by the ore. Otherwise, the ore will be lifted by the broken cone and the ore powder will enter the eccentric shaft, causing an accident. The hammer crusher pays attention to the operation of the oil pump, and often checks the oil flow indicator, oil temperature and oil pressure indications everywhere.

The temperature of oil after passing through the cooler should not be higher than 45.53~C, the return oil temperature should not be higher than 60E, and oil should be supplied to the upper suspension device on time. The hammer crusher should pay attention to check the tightness of the triangle belt. The triangle belt can be pressed down with the thumb to determine the tension. If the pressure is less than 1.5m, the tension is appropriate. Check whether there is any fracture phenomenon, and pay attention to the triangle belt do not stick oil. Jaw crusher should always check the connection pin between the beam, frame and frame is loose and along the circumference of 15· Is 0mm gap equal.

Comments

comments

You may also like...

Leave a Reply

Your email address will not be published. Required fields are marked *